Replace The Driver Blade - Signode JOSEF KIHLBERG JK35T590 Mode D'emploi

Josef Kihlberg JK35T590

7.3 REPLACE THE DRIVER BLADE

– Disconnect tool from air supply.
– Remove the four screws (Fig. 8/1) holding the top
cap. Remove the four screws (Fig. 8/1) holding
the top cap.
– Remove the cylinder liner cover (8/2).
– Turn the tool upside down and knock it carefully
against a piece of wood to loosen the driving
parts.
– Remove the driving parts.
– Change the driver blade (8/3).
– Grease (Part No. 184943) all O-rings and sliding
surfaces. Assemble the driving parts as indicated
in the picture.
– Enter the driver into the nozzle and push it down.
Check that the piston and the driver move freely in
the cylinder and in the nozzle.
– Mount the cylinder liner cover.
– Mount the top cap and tighten the four screws
(8/1).
10
1
2
3
Fig. 8
05.20