5. Secure Two Foot Clips (Without Shroud)
Pull out the locking plates on the two foot clips that were traced on the floor and remove the foot
clips.
Position these foot clips on the traced lines and mark the four screw holes.
IMPORTANT! Make sure that the foot clips will be flush with the finished floor after installation. If you
use anchors that protrude above the finished floor, recess the finished floor material around the holes or
recess the anchors so the foot clips are flat against the finished floor.
Carefully drill the four screw hole locations in the finished floor, and secure the foot clips to the
floor using fasteners suitable for the floor material.
Kohler Co.
Unlocked
Position
9
Foot Clip
Finished Floor
Subfloor
1220597-2-G