Hilti SCW 22-A Mode D'emploi Original page 15

5.9 Fitting the guide rail adapter
Note
The saw can be equipped with a guide rail adapter which is available as an accessory.
1. Remove the battery.
2. Remove the rip fence, if one is fitted.
3. Fit the base plate into the side retaining channels of the guide rail adapter.
4. Fully insert the base plate into the guide rail adapter.
5. Lock the guide rail adapter by pressing in the two sliders as far as they will go.
5.9.1 Longitudinal cuts at 0°
1. Place the saw on the guide rail so that the rib fits into the groove in the adapter.
2. Guide the saw along the rail.
5.9.2 Longitudinal cuts at angles up to 50 °
1. Set the angle.
2. Guide the saw along the guide rail with the outer edge of the guide rail adapter on the rib on the guide
rail. The saw blade will otherwise collide with the guide rail.
5.9.3 Making cuts at an angle across the surface of the workpiece
1. Position the guide rail with the zero mark at the edge of the workpiece and then pivot the rail until the
desired angle shown on the angle scale is opposite the zero mark. The cutting angle indicated is the
angle of deviation from a straight, right-angled cut.
2. Use the two screw clamps to secure the guide rail.
5.10 Using the saw without a dust and chip removal system
1. Check that the sawdust is ejected without obstruction.
2. If required, the hose connector can be removed from the blade guard after releasing the hex. socket
screw using the wrench supplied (located on the product).
5.11 Procedure if the chip / dust channel is blocked
1. Pull the battery out of the product to the rear.
2. Clean the chip / dust channel.
Note
Remove the saw blade if necessary.
3. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may
affect operation of the product.
6 Care, maintenance, transport and storage
6.1 Care and maintenance of cordless tools
WARNING
Danger of electric shock! Carrying out care and maintenance while the battery is fitted presents a
risk of serious physical injury and burning injury.
▶ Always remove the battery before carrying out all care and maintenance tasks.
Care and maintenance of the tool
• Carefully remove any dirt that may be adhering to parts.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
Care of the lithium­ion batteries
• Keep the battery free from oil and grease.
Printed: 27.07.2016 | Doc-Nr: PUB / 5292960 / 000 / 00
9
9