Hilti SCW 22-A Mode D'emploi Original page 14

5.4 Adjusting the cutting depth
1. Pull the battery out of the product to the rear.
2. Release the cutting depth adjustment clamping lever.
3. Lift the product in a scissor movement and set the desired cutting depth by closing the clamping lever.
Note
The cutting depth should always be set to a depth approx. 5 to 10 mm greater than the thickness
of the material to be cut.
5.5 Setting the cutting angle
1. Pull the battery out of the product to the rear.
2. Release the cutting angle adjustment clamping lever.
3. Pivot the product into the desired position.
4. Tighten the cutting angle adjustment clamping lever.
5.6 Inserting the battery
WARNING
Risk of injury! Inadvertent starting of the circular saw.
▶ Before fitting the battery, check that the circular saw is switched off and that the safety lock is not
pressed in (i.e. safety lock is active).
WARNING
Electrical hazard! Risk of short circuiting.
▶ Before inserting the battery, check to ensure that the battery terminals and the contacts on the
circular saw are free from foreign objects.
WARNING
Risk of injury! Hazard presented by a falling battery.
▶ A falling battery may present a risk of injury to yourself and others. Check that the battery is
securely seated in the circular saw.
▶ Push the battery into the product from the rear as far as it will go and until it is heard to engage with a
double click.
5.7 Sawing along a line
Note
Secure the workpiece to prevent movement.
Position the workpiece so that the saw blade is free to rotate beneath it.
Check to ensure that the on/off switch on the product is in the "off" position.
Position the forward section of the saw's base plate on the workpiece but do not bring the blade into
contact with the workpiece.
1. Fit the battery into the product.
2. While pressing the safety lock, switch the product on by pressing the on/off button.
3. Guide the product along the cutting line on the workpiece at a suitable speed.
5.8 Fitting / adjusting the rip fence (parallel guide)
1. Pull the battery out of the product to the rear.
2. Screw the clamping screw into the baseplate, leaving enough space to slide the parallel guide through.
3. Slide the rip fence guide under the clamping screw.
4. Set the desired cutting width.
5. Tighten the clamping screw.
8
Printed: 27.07.2016 | Doc-Nr: PUB / 5292960 / 000 / 00
5
6
2
7
8