Publicité
Les langues disponibles
Les langues disponibles
Pinlock
30
®
The plastic lens in the Pinlock
visor absorbs moisture. The air
pocket between the lens and visor reduce the
difference between the temperature inside the
helmet and the outdoor temperature.
Integrated sun shield
High-strength HCM
outer shell
High Density Copolymer Ma-
trix: High quality ABS plastic is
formed under extreme heat and
pressure to make a robust and
impact-resistant outer shell.
Anti-scratch coated
visor
Separate winter com-
fort collar
Removable, washa-
ble liner
Toolless visor changes
With an additional set
of cheek pads for a cus-
tom fit
Suitable for eye-
glass wearers
Safety lock closure
Date of manufacture
(month/year):
30
GB
®
11/2020
Use and Installation
Instructions
Sun Shield (Fig. C)
The integrated sun shield (10) will enable you
to quickly and easily react to changed light con-
ditions with the aid of the patent mechanism.
To pull out and retract the sun shield, press the
safety latch to operate the slider (5).
Note:
• Please take care that the edge of the sun
shield does not block your field of vision.
• The sun shield may only be used when the
visor is closed and may only be used during
the day.
Inner Lining (Fig. D)
The inner lining (15) can be completely
removed and cleaned separately (see care
instructions).
To remove the inner lining, firstly remove the
helmet collar and the cheek pads. Then undo
the back press-studs of the inner lining and pull
the clips of the inner lining from the front side of
the helmet.
Snap-Fastener System (Fig. E)
The snap-fastener enables an individual and
quick vernier adjustment of the chin strap.
Press the snap-fastener together until the helmet
is sitting comfortably but firm.
The movable buckle may be used to fasten or
secure excess chin strap.
Chin-Wind Deflector (Fig. F)
The chin-wind deflector (12) can be removed
or fixed as needed. To fix, slide the chin-wind
deflector into the chin bar.
Cheek Pads (Fig. G)
You will receive two different pairs of cheek
pads (14) for individual size adjustment.
The thinner cheek-pads are already pre-mount-
ed as standard. The thicker cheek pad is
enclosed with the helmet separately.
If the helmet is too loose and therefore is not
sitting firmly on your head, you can replace the
thin cheek pad with the thicker ones.
Publicité
