Firmware Update - sylvac D70S Manuel D'utilisation

Firmware update

The D70 internal software can be updated.
Updating requires an RS232 cable (ref. 926.5606 for D70S and ref 804.2201 for D70H/I) . It is
possible to use an RS232/USB converter if your PC is not equipped with a serial port.
If you do not have an RS232 cable, you can connect it as in this diagram:
Updating the firmware requires the «flash magic» software, which can be downloaded free of
charge from this address: www.flashmagictools.com
After installation, configure the software as follows :
Procedure
1
the computer with the cable
USB/RS232.
2
3
magic software according to
the image above.
4
Updating will take between 2
and 5 minutes depending on
the speed chosen. During up-
dating the screen is locked.
5-
matically when the procedure
is completed.
6-
following the procedure des-
cribed before.
22
– Connect the D70 to
– Switch on the D70.
– Configure the flash
– Click on "Start" .
The D70 restarts auto-
Reinitialise the D70 by