Temporary Dynamic Measurement Mode - sylvac D70S Manuel D'utilisation

You can switch between the two modes by tapping the display areas within the red dots below:

Temporary dynamic measurement mode

As explained in section 5.1, the value is defined as «static» or «dynamic» (min, max, etc.)
If a value is set as static, it is still possible to temporarily switch to dynamic mode directly from
the measurement screen.
Tap the measurement mode symbol to do this.
It cycles through:
Static measurement
Once a dynamic measurement mode is selected, tap the «clear» button to launch the meas-
urement, or use the pedal if this has been set to «Start dyn» (see the «Configuration» section).
Max Min
15
Max-Min Mean
Average
E
Median
Average