VONROC CR504AC Traduction De La Notice Originale page 7

TECHNICAL SPECIFICATIONS
Model No.
Compressor type
Compressor drive
Voltage
Frequency
Input power
Horsepower
Operating mode
Idling speed
IP class
Protection class
Air intake
Output (compressed air) at
7 bar
Output (compressed air) at
4 bar
Max. outlet pressure
Cut-in pressure approx.
Cut-out pressure approx.
Tank capacity
Cable length
Weight
Sound pressure level
Sound power level
* S3 = intermittent operation without the impact of
the start-up. This means that during a period of 10
minutes, the maximum operating time is 50% (e.g.
5 minutes of work and 5 minutes of rest) , under
optimal environmental conditions (max. temp
25°C). Respecting these guidelines and the prescri-
bed maintenance intervals will allow the product to
work properly over time.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
WWW.VONROC.COM
CR504AC /
CR504AC_GREY /
CR504AC_WHITE
Piston - oil free - low
noise
Direct drive
220-240V~
50 Hz
750W
1 HP
S3 50% *
1450/min
IP30
Class I
128 l/min
42 l/min
65 l/min
8 bar
6 bar
8 bar
6L
2m
16 kg
L
= 79.7 dB(A)
pA
K = 3 dB(A)
pA
L = 92.7 dB(A)
WA
K = 3 dB(A)
WA
1. Cover
2. Switch
3. Pressure switch
4. Pressure regulator
5. Quick coupler (outlet)
6. Pressure gauge (operating pressure)
7. Pressure gauge (tank pressure)
8. Safety valve
9. Handle
10. Pressure pipe
11. Drain cock
12. Air inlet
13. Air filter
14. Overload switch
15. Tank
16. Rubber feet
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Mounting the air filter (Fig. A, B)
1. Remove the transport lid and replace them with
the supplied air filter (13) before using the com-
pressor.
2. Mount the air filter (13) by screwing the air filter
(13) clockwise into the air inlet (12) as shown
on figure B.
Installing the compressor
• The compressor should be installed in ventila-
ted and dry environment.
• Make sure the compressor is placed on the
horizontal and stable ground.
• Place the compressor on a flat surface or at a
maximum slope of 10°, in a well ventilated area,
protected against atmospheric factors and not
in explosive surroundings.
• If the surface area is sloping and smooth, make
sure that the compressor will not move when in
operation.
• For proper ventilation and effective cooling, it is
important that the compressor is positioned at
least 50 cm away from any wall or obstacle.
• Make sure that the compressor is transported
in the right way, do not turn it upside down and
don't lift it with hooks or ropes.
EN
7