Waeco BordBar BB-28 Notice D'utilisation page 21

BB-28.book Seite 21 Freitag, 18. März 2005 4:58 16
All manuals and user guides at all-guides.com
BB-28
9 Troubleshooting
Fault
Your cooler is not
working and the fan
wheel which can be
seen from the outside
is not turning.
The ignition is on and
the cooler is not
working.
Pull the plug out of the
socket and make the
following checks.
The ignition is on and
the cooler is not
working.
Your cooler does not
cool satisfactorily and
the outer fan wheel is
not turning.
The cooler does not
cool satisfactorily and
the outer fan wheel is
turning.
Possible cause Suggested remedy
There is no voltage The ignition must be switched on in most
flowing from the vehicles for voltage to flow at the
cigarette lighter in cigarette lighter.
your vehicle.
The cigarette lighter Clean the socket of the cigarette lighter
socket is dirty. This with a non-metallic brush and a solvent,
results in a poor to ensure that the middle contact pin is
electrical contact. clean. If the plug of your cooler becomes
very warm in the cigarette lighter socket,
either the socket must be cleaned or the
plug has not been assembled correctly.
The fuse of the Replace the connection cable fuse (5 A).
connection cable
has blown.
The vehicle fuse has Replace the vehicle cigarette lighter fuse
blown. (usually 15 A). Please refer to the
operating manual of your vehicle.
The battery monitor Recharge the vehicle battery.
has acted because When the the battery monitor switches
the supply voltage the device off, the battery still has around
has sunk below 20% of its charging capacity. Avoid
11.7 V. starting repeatedly or operating current
consumers without long charging phases.
Ensure that the battery is recharged.
The fan motor is This can only be repaired by an
defective. authorised customer services unit.
The fan motor for the This can only be repaired by an
inner fan is authorised customer services unit.
defective.
The Peltier element
is defective.
21