ETNA KIF670ZT Mode D'emploi page 41

OPERATION
Start cooking
Use of the touch keys
Put the tip of your finger flat on the touch key. Do not apply pressure.
The touch keys react to a light fingertip touch. Only operate the touch keys with your finger.
The touch key gives a short audio signal when it engages.
1. Touch and hold the On/Off key until you hear an audio signal.
The On/Off Indicator light appears.
▷
▷ All displays show '0' indicating that the induction hob has entered the state of
standby mode.
2. Place a suitable pan on the cooking zone.
Make sure the bottom of the pan and the surface of the cooking zone are clean and dry.
▷
• Touch the '+' or '-' key of the desired cooking zone.
Touching the '+' key for the first time displays setting '9'.
▷
Touching the '-' key for the first time displays setting '4'.
▷
▷ A short audio signal will sound.
The power level indicator is flashing.
▷
When the pan detection symbol flashes:
• you have not placed a pan on the correct cooking zone;
• the pan you're using is not suitable for induction cooking;
• the pan is too small or not properly centered on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
▷
▷ The display will automatically turn Off after 2 minutes if no suitable pan is placed on it.
If the hob is not used for 10 seconds, it will shut off automatically.
EN 15