FITFIU FITNESS MC-80 Manuel D'instructions page 13

ANNEX
TROUBLESHOOTING/PROBLEM SOLVING
PROBLEM
CAUSE
The equipment does A. The equipment is not plugged in.
not switch on B. The safety strap is not in place.
The tape skates The tape is loose.
Treadmill oscillates A. Not sufficiently lubricated.
when stepped on B. It is too tight.
Tape is not centred The tension of the treadmill is incorrectly set on
the rear wheel.
Display shows: E00 or The safety sensor is not in place.
E07
A communication problem has been detected
Display shows: E01 or
between the drive disk and the console.
E13
Display shows: E02 or A problem has been detected in the disk
E06 or E10 drive/engine.
The display shows: E03 A problem has been detected with the speed
sensor.
The display shows: E04 Tilted belt, motor problem detected.
The display shows: E05 The electrical protection has tripped.
The display shows: E08 A problem has been detected in the control unit.
The display shows: E09 A stability problem has been detected.
The display shows: E11 The power supply protection has tripped.
or E14
The equipment is The surface is not flat.
unstable
SOLUTION
A. Connect the unit to the mains.
B. Place the safety strap in the correct location.
Adjust the belt tension.
A. Lubricate the running board.
B. Adjust the belt tension
Adjust the belt alignment.
Position the safety sensor in the correct place on the console.
Check the connections between the console and the disk drive. If the
connectors or wiring are damaged, replace them.
Check that the mains supply is according to specifications. Check the
drive unit and motor connections, if damaged, replace them.
Check all connections, if the motor or control unit is damaged, replace it.
Check all connections, if the motor or control unit is damaged, replace it.
Check that the mains power supply is in accordance with the
specifications. Make sure the treadmill is not snagged or unable to rotate
because of an obstruction. Check all connections. Check the motor or
control for short-circuit faults (usually indicated by a burning smell) and
replace parts as necessary.
Check all connections, if the control unit is damaged, replace it.
Ensure that the machine is properly unfolded and placed on a flat and
level surface. Check all connections, if the control unit is damaged,
replace it.
Ensure that the machine is properly unfolded and placed on a flat and
level surface. Check all connections, if the control unit is damaged,
replace it.
Place the machine on a flat surface. If applicable, rotate the legs
underneath the front of the machine to move it up or down as necessary
to make the equipment stable.
disposal and recycling
Los productos desgastados son potencialmente reciclables y no deben desecharse en la basura
habitual. Ayúdanos a proteger el medio ambiente y a preservar los recursos naturales. Deshazte del
aparato de manera ecológica. No lo tires con la basura doméstica. Sus componentes de plástico y de
metal se pueden separar y reciclar. Lleva este aparato a un centro de reciclado homologado (punto
verde). Los materiales utilizados en el embalaje de la máquina son reciclables: por favor, tíralos en el
contenedor adecuado.
GUARANTEE
This product is guaranteed for 3 years from the date of purchase. The warranty covers breakdowns and
malfunctions of components not considered as consumables*, provided that it is used in accordance
with its intended use and according to the instructions in the manual. In order to claim under the
warranty, proof of purchase (receipt or invoice) is required and the product must be complete and with
all its accessories.
The warranty clause does not cover deterioration caused by wear and tear, lack of maintenance,
negligence, incorrect assembly or improper use (knocks, non-compliance with power supply advice,
storage, conditions of use, etc.). The consequences of the use of accessories or spare parts which are
not original or not suitable for the assembly or modification of the appliance are also excluded from
the guarantee.
*for more information on the components covered by the warranty, visit the website
www.fitfiu-fitness.com
13
- MC-80
§ ¨