Publicité
Les langues disponibles
Les langues disponibles
en
= on each occasion the display
Manual
tex
t Launch rinsing cycle
In this case, check that all drip trays are in
place, and press button f (large cup); the
appliance is rinsed.
Reset
serves to reset all settings changed in
Yes
programming mode and any changes to the
liquid quantity are reset to the original ex
works values.
Care and daily cleaning
Danger of electric shock!
!
Before cleaning, unplug the appliance
from the mains supply.
Never immerse the appliance in water.
Do not use a steam cleaner.
● All loose parts must be washed by hand.
● Wipe the housing and window, using only
a soft, damp cloth.
● Do not use abrasive cleaning materials.
● Rinse out the water tank 5 with water
only.
● Remove the drip tray 11 with its cover
grille.
● Remove the large drip tray 12, together
with the cover grille and the capsule
container 13, by pulling forwards (Fig. 6).
● Wash all parts with a mild detergent
solution.
● When relocating, ensure that all parts are
properly seated.
● First pull the coffee dispenser 14 forwards
out of its location, followed by the capsule
holder 15 (Fig. 8).
● Clean with a detergent solution and a soft
brush (not dishwasher-safe).
● Slide the capsule holder 15 back into
position, followed by the coffee dispenser
14.
20
All manuals and user guides at all-guides.com
Nozzle 10 for hot water/steam
appears.
● Unscrew the nozzle 10 from the steam
● Dismantle all parts (Fig. 7).
● Clean with a detergent solution and a
● Rinse all parts with clean water, and dry
Frothing attachment 9
The individual parts of the frothing
attachment 9 must always be kept clean.
Even the smallest milk residue will impair
the frothing results.
Accordingly, the frothing attachment 9 must
be rinsed through with water immediately
after use:
● Dip the tube in a vessel containing cold
● Place a second vessel under the nozzle
● Set the selector of the frothing attachment
● Press the steam button
● When the display alternates between
● Rinse the frothing attachment 9 through
● To terminate the process, press the
Depending on usage, the frothing
attachment 9 should be disassembled and
cleaned daily, or at least once a week.
● Pull the frothing attachment 9 off the
● Disassemble the frothing attachment 9
● Clean the individual parts carefully with a
pipe.
soft-bristled brush. Clean the front tip of
the nozzle 10/c using a blunt needle.
off.
water.
of the frothing attachment 9.
9 to
(hot milk).
C
and
, press the steam
Steam
ready
button h once again.
for around ten seconds.
steam button
.
h
steam pipe 7 from below (Fig. 5).
(Fig. 4).
detergent solution and a soft brush. Rinse
all parts clean, and dry off. Do not place
them in a dishwasher.
.
h
Publicité
