EINHELL GC-EM 1600/37 Instructions D'origine page 18

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
Explanation of the warning signs on the
equipment (see Fig. 12)
1 = Read the directions for use before operating
the equipment
2 = Keep all other persons away from the danger
zone.
3 = Caution: Sharp blades! Pull out the power
plug before carrying out any repair work or if
the power cable is damaged. The blades will
continue to rotate after the motor is switched
off .
4 = Caution: Keep the power cable away from the
cutters!
5 = Guaranteed sound power level
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Warning!
Read all the safety information, instructions,
illustrations and technical data provided on
or with this power tool. Failure to adhere to the
following instructions may result in electric shock,
fi re and/or serious injury.
Keep all the safety information and instruc-
tions in a safe place for future use.
This equipment is not allowed
to be used by children. Children
should be supervised so that
they do not play with the equip-
ment. Children are not allowed to
carry out the cleaning or mainte-
nance. This equipment is not al-
lowed to be used by people with
Anl_GC_EM_1600_37_SPK13.indb 18 Anl_GC_EM_1600_37_SPK13.indb 18
GB
limited physical, sensory or men-
tal capacities or by those with
insuffi cient knowledge or experi-
ence unless they are supervised
or instructed by a person who is
responsible for them.
2. Layout and items supplied
2.1 Layout (Fig. 1/2)
1. Top push bar
2. Bottom push bar
3. Ejector fl ap
4. Carry-handle
5. Lever for cutting height adjustment
6. Grass basket
7. Filling level indicator
8. Power plug
9. On/Off switch
10. Cable strain-relief
11. Rear wheels
12. Wheel caps
13. Wing nuts for push bar
14. Split pin
15. Washers for wheels
16. Cable clips
17. Fastening screws for push bar
18. Washers for bottom push bar
19. Grass box handle
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
- 18 -
23.11.2023 08:33:01 23.11.2023 08:33:01