Pfannenberg DTI 6801 Serie Manuel D'utilisation page 70

GB
4.2 Multi-Controller operation
1 2
6
Figure 19 - Control panel (MC)
The control panel has four menu settings that are displayed on the LCD (1).
LCD Menu setting
SetP: Switch cabinet temperature setpoint
Lit¯: Maximum switch cabinet temperature value (high limit value)
Lit_: Minimum switch cabinet temperature value (low limit value)
Unit: Unit of the switch cabinet temperature
4.3 Carrying out menu settings
Requirement
-
Cooling unit has started operation.
-
LED light (6) of the control panel illuminates green.
Procedure
 Scroll through the menus (SetP, Lit¯, Lit_, Unit) from the temperature display (1) with the SCROLL UP (3) and
SCROLL DOWN (4) buttons.
 Select a menu with the SET button (5).
 Enter the password. After pressing the SET button (5) press the SCROLL UP (3) and SCROLL DOWN (4)
buttons within two seconds; see Password button combination figure.
 Always adjust the desired value with the SCROLL UP (3) and SCROLL DOWN (4) buttons.
 Confirm the value with the SET button (5).
 When the BACK button (2) is pressed, the value is not saved.
 Select a different menu by scrolling with the SCROLL UP (3) and SCROLL DOWN (4) buttons.
 If there is no input for 30 seconds, a TIMEOUT is initiated and the LCD switches to temperature display.

Menu is adjusted in the cooling unit.
Operating Manual DTS and DTI 6801 Multi-Controller (MC) 086100008c © Pfannenberg GmbH
4 5
3
1
Password
3
5
1
< 2s
Figure 20 - Password button combination (MC)
4
< 2s
Input
0 – 90 °C
- 55 – 95 °C
- 55 – 95 °C
°C / °F
Page 27 / 43