Pfannenberg DTI 6801 Serie Manuel D'utilisation page 64

GB
3.5 Electrical connection
3.5.1 Multi-Controller (MC) electrical circuit diagram
DANGER
Life-threatening danger due to electric shock
Live units and exposed connection cables can generate an electric shock and cause severe accidents.
 Work on electrical connections must be carried out exclusively by trained, qualified electricians.
 Ensure that the unit is voltage-free before routing all electrical connections.
Note
The compressor can be destroyed if the phase sequence is incorrect
 Always check the phase sequence before commissioning the three-phase unit.
 Ensure that the phase sequence rotation is clockwise.
Power cable
3x 380V - 420V 50 Hz
3x 440V - 480V 60 Hz
Item Designation
E1 Condensate evaporation
LP1 Controller
M2 Condenser fan
MM2 Multimaster/ output
S1.2 Door close
Temperature
TS1
(internal)
X40 Ground terminal contact
Door contact+ terminal
X54
contact +Fault indication
Operating Manual DTS and DTI 6801 Multi-Controller (MC) 086100008c © Pfannenberg GmbH
S1.1
S1.2
Fault
Item Designation
F1 High-pressure pressostat
LP2 Display control unit (MC)
(external) M3 Evaporator
S1 Door contact
SK Fault signal contact (1,2)
sensor Temperature
TS2
(external)
X50 Mains terminal contact
Optional
Compressor:
Only clockwise rotating field
Item
F2-F5
M1
fan (internal) MM1
S1.1
TK
sensor
X28
X51
R
085 000479 11189-858
085 000475 11189-858
Designation
Fuse
Compressor
Multimaster/ input
Door open
Door contact/ signal (4,5)
Service interface (TTL)
Multimaster terminal
contact
Page 21 / 43