Publicité
Les langues disponibles
Les langues disponibles
a Seconds are displayed during the first minute, then
minutes.
Automatic switch-off
10 Automatic switch-off
If you do not change the settings of a hotplate for a
long time, automatic switch-off will be activated.
When the hotplate switches off depends on the heat
setting selected (1 to 10 hours).
The heat to the hotplate is switched off.
sidual heat indicator / flash alternately on the hot-
plate display.
Keep-warm function
11 Keep-warm function
The keep-warm function allows you to melt chocolate
or butter and to keep food or cookware warm.
11.1 Switching on the keep-warm function
Select the hotplate.
1.
Touch the symbol.
2.
a
lights up on the heat setting display.
Energy consumption display
12 Energy consumption display
This function indicates the total amount of energy con-
sumed between switching the hob on and switching it
off again.
Once switched off, the energy consumption is dis-
played in kilowatt hours, e.g. 1.08 kWh, for
10 seconds.
Basic settings
13 Basic settings
You can configure the basic settings for your appliance
to meet your needs.
13.1 Overview of the basic settings
This is where you can find an overview of the basic set-
tings and the factory preset values.
Dis-
Selection
play
Automatic childproof lock
– Switched off
– Switched on
– Manual and automatic childproof lock are
switched off.
1
Factory setting
and the re-
1
Switching off the stopwatch function
Touch
again.
▶
a The timer display goes out.
10.1 Continuing cooking after automatic
switch-off
1.
Touch any touch field.
a The display goes out.
Reset.
2.
11.2 Switching off the keep-warm function
Select the hotplate.
1.
Touch the symbol.
2.
a
lights up on the heat setting display.
The accuracy of the display depends on various factors
such as the voltage quality of the power supply.
The display can be activated in the basic settings.
→ Page 41
Dis-
Selection
play
Signal tone
– Confirmation signal and operating error
signal are switched off. The main switch sig-
nal remains switched on.
– Only the operating error signal is
switched on.
– Only the confirmation signal is switched
on.
– Confirmation signal and operating error
signal are switched on.
Factory setting
1
Automatic switch-off en
1
41
Publicité
