bosal 017-821 Instructions De Montage page 19

The fact that the towing bracket has been mounted to the vehicle must be entered in the
vehicle papers at the next possible opportunity. The mounting instructions must be added to
the vehicle papers.
General Installation Intructions:
If present, remove insulating compound and/or underseal in the area of the towing bracket
contact surfaces. Coat bare bodywork with anti-corrosion paint.
Mount 7-pin electrical system as per DINV 72570.
Mount 13-pin electrical system as per ISO 11446.
Retighten all mounting bolts of the towing bracket after aprox. 1000 towing km. Please note,
that after mounting the drawbar the mass of your vehicle will change.
Mounting instructions:
Strip the luggage trunk upholstery, then remove the bumper.
–
Remove the bumper insert (it will not be reinstalled later).
–
Put the drag hook into the chassis extension so the factory holes of the extension
–
coincides with the holes („a") of the drag hook in case of Seat Toledo II., or with
holes „b" in case of Seat Leon.
According to drawing instruction fix the drag hook at „a" or „b" positions with the
–
attached bonding units.
Cut off the bumper with the attached gauge.
–
Loosen the bolt at the „A" position of the drawbar eye, then pull out the one at the „d"
–
position. After this pull the bumper on the drawbar eye then fix it to the car.
Reinstall the drawbar eye at the „A" and „d" positions and tighten the bolts.
–
According to requirements carry out connecting of electric wires breaking the rear
–
of cables.
Only specialised services are authorised to install drawhooks.
–
the
sheaf
19