KitchenAid KUDD01S Guide D'utilisation Et D'entretien page 12

Canceling a Cycle
To end a wash cycle in mid-cycle, press the Power button.
Any water in the drawer will be pumped out.
Pausing a Cycle
To pause the drawer during its wash cycle, press START/
RESUME and wait for 3 beeps before opening.
Restart by pressing START/RESUME.
IMPORTANT: Forcing the drawer open in mid-cycle may cause
damage to the dishwasher.
NOTE: If the drawer is operating and a power failure occurs, it
will stop. The drawer may not be opened during this time. When
the power supply resumes, the drawer will restart in the same
part of the wash cycle.
Changing a Cycle or Setting
1. Press the Power button to end the current cycle. Wait for the
drawer to drain.
2. When the draining stops, open the drawer.
3. Press the desired wash cycle button to select the desired
wash cycle. The lighted indicators will progress until the
desired cycle is selected.
4. Check the detergent dispensers. They must be filled properly
for the new cycle. (See "Detergent Use.")
5. Close the drawer.
6. Press START/RESUME.
12
HI
OR
TEMP
Adding Items During a Cycle
You can add an item anytime before the main wash starts. Open
the drawer and check the detergent amount. If the detergent is
still visible, you can add items.
To add items
1. Press START/RESUME and wait for 3 beeps before opening
the drawer.
2. If the detergent is still visible in the detergent dispenser, you
may add the item.
3. Close the drawer firmly.
4. Restart by pressing START/RESUME.
IMPORTANT: Forcing the drawer open in mid-cycle may cause
damage to the dishwasher.
Option Selections and Adjustments
After using the dishwasher, you may want to use or adjust some
of the preset options available to suit your needs. You can select
the Lock button, Control lock, Keylock or Delay Start mode. You
can adjust the settings for Rinse Aid, Auto Power, and End of
Wash Program beeps.
NOTE: Indicator light colors vary depending on your dishwasher.
See following descriptions.
Lock button
The Lock button activates/deactivates the Control lock or the
Keylock functions.
Use the Lock button to prevent unintended use of the
dishwasher. You can also use either of the lock options to prevent
unintended cycle or option changes during a wash cycle.
Control lock
The Control lock feature disables all of the buttons on the
dishwasher.
1. To activate, press and hold the Lock button until you hear
1 beep (about 3 seconds).
2. To cancel, press and hold the Lock button until the light
disappears.
Keylock
The Keylock feature locks the drawer closed and disables the
dishwasher and all buttons.
1. To activate, press and hold the Lock button until you hear
the 2 beeps (about 5 seconds).
2. To cancel, press and hold the Lock button until the light
disappears.