KitchenAid KUDD01SSSS Instructions D'installation

IMPORTANT: A qualified service technician should perform this
installation. Wear gloves and handle panels gently.
Custom Accessory Kit contains:
■
1 Handle
■ 2 Mounting Screws
Installation Procedures
NOTE: If door panel must be removed to install new door handle,
follow steps below:
Door Panel Removal:
1 Open dishwasher door and use a T-15 Torx™ screwdriver to
.
remove three (3) to four (4) screws on each side - total of six
(6) to eight (8) screws. See below for location of screws to be
removed. Hold inner and outer door panels together until all of
the screws are removed.
screws (some
models use only
(6) screws for
panel removal)
2 Partially close dishwasher door and tilt out the outer door
.
panel. Lift up outer panel and remove. Set panel aside on a
towel or covered surface to avoid scratching.
Installation Instructions
Dishwasher Handle Accessory Kit
Remove (8)
Attaching Handle:
1 Measure and mark the location for the handle. The handle
.
should be centered horizontally on the front of the customer-
supplied custom panel. The vertical location is customer
preference. Mount the handle to the custom outer door panel
using the two (2) mounting screws provided.
IMPORTANT: The screws must not extend beyond the back
surface of the panel. The screw holes should be countersunk for
the screw heads to be flush with the panel.
2 Install the custom door panel, reversing steps 1 and 2 of
.
"Door Panel Removal" section.
For Drawer Dishwasher (Single and Double Drawer)
Door Panel Removal:
Front of drawer
pin
Pin
Attaching Handle:
4 Measure and mark the location of the handle. The vertical
.
location is customer preference. Mount the handle to the
customer-supplied custom outer door panel using the two (2)
mounting screws provided.
IMPORTANT: The screws must not extend beyond the back
surface of the panel. The screw holes should be countersunk for
the screw heads to be flush with the panel.
.
5 Install the door panel reversing steps 1, 2, and 3 of "Door
Panel Removal" section.
.
6
Repeat steps 1-5 to install the handle on the other dish
drawer (for Double Drawers).
1 Remove the pins on both sides
.
of the dishwasher drawer by
pulling the pins straight out
with a pair of needle-nose
pliers.
2 Gently pull the bottom of the
.
panel away from the
dishwasher and then pull
down.
3 Remove the three (3) screws
.
on each side from the three
inner holes to access back of
front panel.
W10084565A