Manual Code Search; Auto Code Search; Code Identification - THOMSON ROCZ107 Mode D'emploi

5.1 Manual code search

Your Universal Remote Control is equipped with an
internal memory, which is preloaded with up to
350 codes per device type for the most common
TV/STB devices. You can zap through these codes
until the device you want to control shows a
reaction. This might be that the device you want to
control switches off (POWER key) or changes the
channel (CH+/CH- keys).
5.1.1 Turn on the device you want to control
5.1.2 Press and hold the device button which you
want to control (e.g. TV) for 3 seconds until
the LED is on.
5.1.3 Press the "POWER" or the CH+/CH- key to
zap through the preloaded codes until the
device you want to control reacts.
5.1.4 Press MUTE to save the code and exit the
code search. The LED indicator turns off.
Note
► Internal memory limitations allow only up to 350
most common device codes to be preloaded.
Due to the extensive number of different availa-
ble TV/STB devices on the market, it may be pos-
sible that only the most common main functions
are available. If so, repeat steps 5.2.1 to 5.2.5 to
find a more compatible code. No code may be
available for some special device models.

5.2 Auto Code Search

Auto Code Search uses the same preloaded codes
as the Manual Code Search (5.2) but your Universal
Remote Control scanns through the codes automa-
tically until the device you want to control shows
a reaction. This might be that the device you want
to control switches off (POWER key) or changes the
channel (CH+/CH- keys).
5.2.1 Turn on the device you want to control.
5.2.2 Press and hold the device button which
you want to control (e.g. TV) until the LED
indicator flash once and then keep on.
5.2.3 Press the CH+/CH- keys or POWER to start
the Auto Code Search. The LED indicator
flashes once followed by permanent light.
The Universal Remote Control has a latency of
6 seconds before the first scan starts.
Note: Scan Speed Settings
► Scan Speed Settings can be set at either 1 or
3 seconds. The default setting for the scan
time per single code is 1 sec. If this feels un-
comfortable , you can switch to 3 sec. scan
time per single code. To switch between the
scan times, press CH+ or CH- during the
6 sec. latency before Auto Code Search starts
scanning.
5.2.4 The LED indicator confirms each single code
scan with a single flash.
5.2.5 Press MUTE to save the code and exit the
code search. The LED indicator turns off.
Note
► When all codes are searched without suc-
cess, the Universal Remote Control exits
Auto Code Search and returns to operational
mode automatically. Currently stored code
is not changed.

5.3 Code Identification

The Code identification offers you the possibility, to
determine an already entered code.
5.3.1 Press and hold the device button until the
LED indicator flash once and then keep on.
5.3.2 Press button "AV" two times.
5.3.3 LED indicator flashes times means the code.
Like code 1234, LED indicator will flash once
and pause approx.2s, flash two times and
pause approx.2s, flash 3 times and pause
approx.2s, then flash 4 times and pause
approx.2s. (Number 0 and number 1 both will
flash once, but number 0 will flash very fast).
3