Gaggenau AW240120 Notice D'utilisation page 18

Intensive setting
You can use the intensive setting if there is a large build-
up of odours and fumes/vapours.
#
1 Press the button.
The fan starts at speed 2.
Ž
2 Press the button.
The intensive setting is activated.
Note: If you press the
running at speed 1, 2 or 3, the electronics
automatically switch back to the previously selected
fan speed after 6 minutes.
#
3 Press the button or the button for another fan
speed.
The intensive setting is deactivated.
Automatic mode
Switching on
#
1 Press the button.
The fan starts at speed 2.
<
2 Press the button.
The optimum fan speed 1, 2 or 3 is set automatically
by a sensor.
Switching off
< #
Press the or button.
Automatic mode is switched off.
The fan switches off automatically if the sensor no
longer detects a change in the air quality of the room.
The automatic mode lasts 4 hours at most.
18
Ž
button while the fan is
Sensor control
In automatic mode, a sensor in the extractor hood
detects the intensity of the cooking and roasting fumes.
Depending on the setting of the sensor, the fan
automatically switches to another fan speed.
Default sensitivity setting: 2
Lowest sensitivity setting: 1
Highest sensitivity setting: 4
Changing the sensitivity of the sensor
If the sensor control reacts too quickly or too slowly,
change the sensitivity setting.
1 When the fan is switched off, press and hold the
button for approx. 4 seconds.
The setting is displayed.
2 Press button 1, 2, 3 or the
sensitivity setting.
Button 1 = Sensitivity 1
Button 2 = Sensitivity 2
Button 3 = Sensitivity 3
Ž
button = Sensitivity 4
3 Press and hold the
4 seconds.
The change is saved.
Saturation display
When the metal mesh grease filters are saturated, a
signal sounds for approx. 4 seconds after the fan is
switched off. The saturation indicator
If you have not yet done so, the metal grease filters
should be cleaned now.
For instructions on how to clean the metal grease filters,
please refer to the
Cleaning and maintenance
Resetting the saturation indicator
œ
Press and hold the button until the saturation
indicator is no longer lit.
The saturation indicator is reset.
Ž
button to change the
<
button for approx.
œ
also lights up.
section.
<