Publicité
BEFORE REQUESTING SERVICE
WARNING
Disconnect the electrical supply before performing maintenance to the vacuum cleaner.
Failure to do so could result in electric shock or personal injury from vacuum cleaner
suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance problems.
Any service needed, other than those described in these Operating Instructions,
should be performed by an authorized service representative.
PROBLEM
POSSIBLE CAUSE
Vacuum cleaner
1. Unplugged at wall outlet.
won't start.
2. Tripped circuit breaker/blown fuse
at household service panel.
3. Loose hose electrical connections.
Poor job of dirt
1. Full or clogged dust bag.
pick-up.
2. Clogged airflow passages.
3. Dirty safety filter.
4. Wrong pile height setting.
5. Open suction control.
6. Hole in hose.
7. Worn POWER NOZZLE brushes.
8. Worn or broken belt.
9. Dirty agitator or end caps.
10. Canister hood open.
Vacuum cleaner starts but
1. Hose or hood electrical connections.
cuts off.
2. Tripped overload protector in
POWER NOZZLE.
3. Tripped thermal protector
in canister.
Power Nozzle will not
1. POWER NOZZLE connections unplugged.
run when attached.
2. Worn or broken belt.
3. Dirty agitator or end caps.
4. Tripped overload protector in
POWER NOZZLE.
Vacuum Cleaner picks up
1. Wrong pile height setting.
moveable rugs -or- Power
2. Suction too strong.
Nozzle pushes too hard.
Light won't work.
1. Burned out light bulb.
Cord won't rewind.
1. Dirty power cord.
2. Cord jammed.
Vacuum cleaner leaves marks
1. Wrong vacuuming pattern.
on carpet.
Electric Shock or Personal Injury Hazard.
POSSIBLE SOLUTION
1. Plug in firmly, push ON/OFF switch to ON.
2. Reset circuit breaker or replace fuse.
3. Reconnect hose ends.
1. Change bag.
2. Clear airflow passages.
3. Replace filter.
4. Adjust setting.
5. Adjust control.
6. Replace hose.
7. Replace agitator.
8 & 9. See REMOVING BELT and REPLACING
BELT.
10. Close and latch hood.
1. Check connections, reconnect hose
ends.
2. Remove any items that may be caught
or jammed, then reset. If vacuum cleaner
starts and stops again, clean agitator and
end caps, then reset.
3. Change dust bag, clear airflow blockage.
Wait 30 minutes for motor to cool and
automatically reset.
1. Plug in firmly.
2 & 3. See REMOVING BELT and REPLACING
BELT.
4. Remove any items that may be caught
.
or jammed, then reset. If vacuum cleaner
starts and stops again, clean agitator and
end caps, then reset.
1. Adjust setting.
2. Open suction control.
1. Change light bulb.
1. Clean the power cord.
2. Pull out cord and rewind.
1. See VACUUMING TIPS.
- 49 -
Publicité
