Zodiac Power Force Serie Notice D'installation Et D'utilisation page 24

❶ Installation
1.1 I Selecting the location
• The device must be installed at a minimum distance from the pool's surrounding edge.
This distance is determined by the electrical standards which apply in the installation country.
• Do not lift the device by the body; use its base.
• Install the device outdoors; provide free space around it (see § "1.2 I Hydraulic connections").
• Install the 4 anti-vibration studs under the base and place the device on a stable, solid and level surface.
• This surface must be able to bear the weight of the device (in particular in the case of installation on a roof, a balcony
or any other support).
• The appliance may be secured to the ground using the holes in the base of the appliance.
The device must not be installed:
• In a location subject to high winds,
• With the blowing towards a permanent or temporary obstacle (window, wall, hedge, awning, etc.) less than 4 metres
away,
• Within range of water or mud jets, sprays or run-off (take the effect of the wind into account),
• Near a heat source or flammable gas,
• Near high frequency equipment,
• In a location where it would be subject to snow build-up,
• In a location where it might be flooded by the condensation produced by the device when operating.
Tip: reduce any noise annoyance from your heat pump
• Do not install it under or towards a window.
• Do not tilt it towards your neighbours.
• Install it in a clear space (the sound waves are reflected on surfaces).
• Install an acoustic screen around the heat pump, respecting the distances.
• Install the anti-vibration studs under the heat pump and replace them regularly.
• Install 50cm of flexible PVC pipe at the heat pump water input and output (stops vibrations).
EN
5