Hoshizaki PREMIER SL/PT 2 Manuel D'utilisation, D'entretien Et D'installation page 5

PREMIER PREP TABLE & SALADETTE
II. OPERATING INSTRUCTIONS
ELECTRICITY
Before connecting the product to electrical power, please verify that the specified electrical power
supply on the product description label corresponds with the local network electrical power supply.
The Product Description label with the specified electrical power supply can be found on the inside of the
cabinet, at the top left-hand side.
Installation of the product must only be undertaken by qualified and trained service personnel as per the
specifications listed in this manual.
Electrical safety of this cabinet can only be valid if it's earthed in accordance to current local laws and
regulations.
Earthing of the product is always required.
The manufacturer will not accept any responsibility for any damage arising from improper grounding.
Adhere to all electricity requirements stipulated by the local electrical regulations. The product's
electricity plug, and wall socket must have the correct earth connectivity reading. If necessary, employ a
qualified electrician.
GENERAL PRELIMINARY CHECKS
Make sure the cabinet is standing on level ground. All legs/castors should be on the ground. This is
necessary for the proper operation of the cabinet .
Do not place the cabinet next to any heat generating devices such as ovens, grills, and deep fryers. Do
not expose to direct sun light. Heat that may be radiated by walls or floors must be insulated with appropriate
insulating material. The cabinet should be placed as far as possible from any heat source.
If the cabinet is re-located, allow three hours before re-starting. Plastic protection or tape should be
removed from the outer surfaces.
Ensure the cabinet is positioned so sufficient fresh air can flow to/from the cooling circuit and around the
surfaces of the cabinet.
If two refrigerators or freezers are to be placed side by side, there should be at least 50 mm. space
between them.
Do not block any vent holes.
PRELIMINARY ELECTRICAL CHECKS
• Check that the mains voltage and frequency of the socket conform to the information
on the product description label.
• The cabinet is connected to a mains outlet with a 13-16 Amp fuse as a serial
connection.
• Turn off the mains fuse connected to the power cable.
• Check that the plug on the cabinet is suitable for use with the available mains socket
and that they fit together.
EN
5