Operating Instructions
On/Off
Press this button to turn the dehumidifier on. By default, the device will start
operation in Hygrostat-Mode (see below) with a humidity setting of 60% RH
in High Fan Speed. Press a second time to turn the unit off. The red power
indicator will be lit on the display to indicate stand-by mode.
Mode
Press to cycle between the three available modes: Hygrostat - Continuous
Drying - Sleep
The corresponding indicator will be lit on the display.
Hygrostat
When the ambient relative humidity exceeds the one set by 3%, the fan will
start and the compressor a few seconds later to start the dehumidifying
process.
When the ambient relative humidity falls below the one set by 3%, the
compressor will stop operating and a few seconds later the fan will also stop.
Note: Both Fan Speed and Humidity can be adjusted in Hygrostat-Mode.
Continuous Drying
The device dehumidifies permanently in High Fan Speed, regardless of the
ambient relative humidity.
Note: No target humidity or speed intensity can be set.
Sleep
When Sleep mode is activated, the display switches off after a few seconds
(only the Sleep mode symbol remains dimly lit) and the Fan Speed will
automatically drop to Low.
Press any button to light up display, without any further action, the display
switches off again after a few seconds. Press Mode Button to exit Sleep Mode.
Note: In Sleep Mode the target humidity is adjustable but Fan Speed cannot be
set to High.
74
|
Instruction Manual ecoQ DryAir 12L Essential