Jaga STRADA HYBRID TPT Manuel D'installation Et D'utilisation page 44

4. SETTINGS
4.1. ADJUSTING THE WATER TEMPERATURE
Adjusting the maximum water temperature for cooling
By reducing the water temperature setting, the unit will
start later. If the water temperature is set higher, the unit
will start sooner.
1. Put the device in the cooling mode
2. Hold down the [Mode] and [+] simultaneously until the last 4 LEDs start flashing.
3. Short press the [-] or [+] button to adjust the set temperature.
4. After 30 seconds, the new settings are automatically saved and the device returns to the selected mode.
4.2. SETTING FANSPEED
1. Select the mode that you want to adjust: Cooling / Heating
2. Select the speed that you want to adjust:
3. Hold down [Mode] and [-] simultaneously until the first 4 LED's are flashing.
44
12 ̊ C
MODE
14 ̊ C
MODE
16 ̊ C
MODE
18 ̊ C
MODE
20 ̊ C
MODE
22 ̊ C
MODE
24 ̊ C
MODE
26 ̊ C
MODE
15 sec
Adjusting the minimum water temperature for heating
By increasing the water temperature setting, the unit will
start later. If the water temperature is set lower, the unit
will start sooner.
In combination with a heat pump, it may be necessary
to reduce the water temperature.
1. Put the device in heating mode
15 sec
24 ̊ C
26 ̊ C
28 ̊ C
30 ̊ C
32 ̊ C
34 ̊ C
36 ̊ C
38 ̊ C
/
STRADA HYBRID TPT/B | MANUEL | 2024.07.01 | V.1.03
factory default water temperature