BWT AQUAMAT 3001 Notice D'installation Et De Maintenance page 24

12. Maintenance and winterizing
The Aquamat 3001 motor does not require any specific maintenance. Simply check that the pit in which it is
installed is not too humid or full of water.
During the winter, the motor should be removed once the slat apron has been rolled out over the pool :
• Unscrew and remove the quick fit connection on the side of the AQUAMAT 3001, leaving the box mounted on
the wall.
• Remove the U-shaped pin by pulling it upwards and remove the AQUAMAT 3001 motor.
• Store the motor protected against bad weather and humidity.
Upon putting is back into operation, carry out this procedure in the reverse order and program the ends of travel.
PROTECTION & SÉCURITÉ 24 2021/09 - Indice de révision : B - Code : 34690