BWT AQUAMAT 3001 Notice D'installation Et De Maintenance page 23

10. Assembling the flywheel
Ref Description
1 Stainless steel nut M8
2 Stainless steel screw 6x100
3 Flywheel Ø 300mm
4 Hand grip
5 Stainless steel screw8x100
6 Stainless steel square not M6
The flywheel is provided to allow the pool to be secured in the event that the motor breaks down.
11. Operating recommendations
Be careful during when operating the cover. Before starting the motor, check :
• that no-one is in the pool before closing it.
• that no floating object or pool robot could hinder movement of the slat cover.
• that the water level is correct (not too high, not too low).
Keep watch over the pool while the slat apron is in motion up until is reaches the end of travel.
PROTECTION & SÉCURITÉ
Qty
2
1
1
1
1
1
23 2021/09 - Indice de révision : B - Code : 34690