Additional Information; Maintenance; Removing The Unit - Sony XR-CA430X Mode D'emploi

Additional Information

Maintenance

Fuse replacement
When replacing the fuse, be sure to use one
matching the amperage rating stated on the
original fuse. If the fuse blows, check the power
connection and replace the fuse. If the fuse blows
again after replacement, there may be an internal
malfunction. In such a case, consult your nearest
Sony dealer.
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as this
could damage the unit.
Cleaning the connectors
The unit may not function properly if the
connectors between the unit and the front panel
are not clean. In order to prevent this, detach the
front panel (page 6) and clean the connectors
with a cotton swab dipped in alcohol. Do not
apply too much force. Otherwise, the connectors
may be damaged.
Main unit
Back of the front panel
Notes
• For safety, turn off the ignition before cleaning the
connectors, and remove the key from the ignition
switch.
• Never touch the connectors directly with your fingers
or with any metal device.

Removing the unit

1
Remove the front cover
1 Detach the front panel (page 6).
2 Press the clip inside the front cover
Fuse (10 A)
3 Repeat step 2 for the other side.
2
Remove the unit
1 Use a thin screwdriver to push in
4 mm
2 Repeat step 1 for the right side.
3 Slide the unit out of its mounting.
with a thin screwdriver.
the clip on the left side of the unit,
then pull out the left side of the unit
until the catch clears the mounting.
17