Cequent Performance Products 51157F Instructions D'installation

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 51157F
Wrenches: 17mm, 19mm
Drill Bits: None
1
Qty. (4) M12 X 1.25 X 40mm CL10.9
1. Remove tie down bracket from the driver's side of the vehicle and return to vehicle owner.
2. Raise hitch into position over existing weldnuts and install the M12 bolts and conical toothed washers as shown above.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2009 Cequent Performance Products
Installation Instructions
Toyota RAV4
Fascia
Frame Rail
Tighten all M12 fasteners with torque wrench to 65 Lb.-Ft.
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV3, SUV4
2
Qty. (4) ½" Conical Toothed Washer
Sheet 1 of 3 51157N
Part Numbers:
51157
Max Gross Max Tongue
Trailer WT (LB) WT (LB)
4000 (1816 Kg) 400 (182 Kg)
3500 (1589 Kg) 350 (159 Kg)
8-17-09 Rev. A