Cequent Performance Products 51141 Instructions D'installation

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 51141F
Wrenches: 13/16, 7/8, 15/16
Drill Bits: None
Slot in Frame
1
Qty. (2) Hex Bolt 9/16-12 x 2-1/2" GR5
2
Qty. (2) Spacer Block ¼ x 1-1/2 x 2
3
Qty. (2) Spacer Block 3/8 x 1-1/2 x 2
4
Qty. (2) Lock Washer – 9/16"
5
Qty. (2) Hex Nut 9/16-12
1. Raise receiver into position and attach with fasteners as shown above.
2. Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Tighten all 9/16-12 GR5 fasteners with torque wrench to 110 Lb.-Ft. (149 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
z 2009 Cequent Performance Products
Installation Instructions
Ford Explorer Sport Trac
Bumper
Wiring Access Location: SUV1, SUV2
Existing Hole
6789
6
7
8
9
Sheet 1 of 3
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Trailer WT (LB)
6000 (2724 Kg.)
Weight Distributing
Weight Carrying
5000 (2270 Kg.)
Ball Mount
Qty. (2) Carriage Bolt ½-13 x 1-3/4 GR5
Qty. (2) Spacer Block ¼ x 1-1/2 x 2
Qty. (2) Conical Toothed Washer
Qty. (2) Hex Nut ½-13
51141N
Part Numbers:
51141
Max Gross Max Tongue
WT (LB)
600 (272 Kg.)
500 (227 Kg.)
12345
8-3-09 Rev. A
Form: F205 Rev A 5-6-05