Cequent Performance Products 51109 Instructions D'installation

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 51109F
Wrenches: 7/8"
Drill Bits: None
Frame Rail
1
Qty. (6) Carriage Bolt ½-13 x 1-3/4" GR5
2
Qty. (2) Spacer Block ¼ x 1-1/2 x 3
3
Qty. (2) Spacer Block ¼ x 1-1/2 x 2
1.
2.
3.
4.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2009 Cequent Performance Products
Installation Instructions
Frame Rail
Fascia
1456
Loosen spare tire.
Raise hitch into position.
Install fasteners as shown.
Tighten spare tire.
Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Nissan Xterra
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV1, SUV2
1356
1256
4
Qty. (2) Spacer Block ¼ x 1 x 2
5
Qty. (6) Conical Toothed Washer ½"
6
Qty. (6) Hex Nut ½-13 GR5
Sheet 1 of 3
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
5500 (2497 Kg.)
3500 (1589 Kg.)
51109N 7-24-09
Form: F205 Rev A 5-6-05
51109
Max Tongue
WT (LB)
550 (250 Kg.)
350 (159 Kg.)
Rev. A