Husqvarna Aspire H50-P4A Manuel D'utilisation page 15

WARNING:
front of the cutting equipment does not
touch the ground.
2. Hold the product near your body for a stable work
position.
3. Be careful and operate the product slowly.
Automatic shutdown function
The product has an automatic shutdown function that
stops the product if it is not used. The product shuts
down after 3 minutes.
Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
WARNING:
you do maintenance on the product.
1888 - 005 - 15.12.2023
Make sure that the
Maintenance
Read and understand the
Remove the battery before
To stop the product
1. Release the power trigger and the front handle
trigger.
2. Push the on/off button until the green LED goes off.
3. Push the release buttons on the battery and remove
the battery. (Fig. 38)
Maintenance schedule
The following is a list of the maintenance steps that you
must do on the product.
15