Publicité
Les langues disponibles
Les langues disponibles
Operatin
instructions
Status
window
That STATUS window displays codes typically seen
during normal operation or programming of the
dishwasher. The STATUS window indicates the
following activity:
1 h - 24h
CL
hoe
Indicates number of
delay start hours for
selected cycle.
Flashes once the
program has been
entered and the
START pad is pressed.
It also flashes if the
door is opened during
a wash cycle. Close
the door to begin or
continue the wash cycle,
Child Lock is activated.
Minutes
L1 - L4
The cycle duration or
the remaining time.
Level of Rinse Aid
Dosage.
Blue
light
indicator
When the BLUE LIGHT illuminates on the floor this
indicates that the wash cycle is complete.
Error
Codes
Displayed
Error Code*
i10
i20;
i40;
iF0
i30
Problem
A low fill has been detected.
Clogged filters or a restricted
drain line has been detected.
A leak or overflow of water
has been detected in the
bottom pan.
Solution
Look for a pinched water supply line, or water shutoff is
not completely opened.
Check and clean both filters and sump area and check
for a pinched or blocked drain hose. If the drain line is
attached to a disposer, check that the knockout plug
has been removed.
Look for loose connections at the water inlet valve and
ensure the unit is properly leveled,
A problem has been
i50
detected with the drain or
wash motor,
Pressing the cancel button or turning power off at the
A problem has been
breaker for 5 min. should clear this error code and
i60
detected with the water
the unit can be restarted,
heating system,
A problem has been
If this does not resolve the problem, service
iC0
detected with the electronic
will need to be called.
control
system.
*In all Error Code instances, if Pressing the cancel button or turning power off at the breaker for 5 min.
does not resolve the problem,
contact the Electrolux Customer Care Center at 1-877-435-3287.
Publicité
