For The First Time - Royalty Line EMG-1200.2 Mode D'emploi

manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
• The blade is sharp, always pay close attention in using.
• Put the appliance in flat and firm surface.
• Never let it near or close to the open fires or inflammable issues.
• The attachments were intended by manufacturer. Do not try to
replace or change them or for other purpose.

FOR THE FIRST TIME

• Check that voltage indicated on the rating label corresponds the
mains voltage in your home.
• Wash all parts (except body) in warm soapy water.
• Before plugging in, ensure the ON/OFF/Reverse switch is turned to
"OFF" position.
INSTRUCTION
FOR USE
ASSEMBLING
• Hold the head and insert into the head
inlet, screw the fasten handle clockwise
till it's tight ( fig.1,fig 2)
• Place the snake into the head, turn it
slightly until it is set into the motor
housing (fig.3).
• Place the cutting blade onto the snake
shaft , Attention : the cutting side must
face out (fig.4).
If it is not fitted properly, meat will not
be grinded.
• Place the desired cutting plate next to
the cutting blade, fitting protrusions in
the slot (fig.5).
• Support or press the centre of the
cutting plate with one finger then screw
the fixing ring tight with another hand
(fig.6). Do not over tighten.