Publicité
The overspeed governor must release the safety gear.
The safety switch must release and switch off the safety circuit of the elevator plant.
With a slow movement upwards and/or downwards, place the overspeed governor and the safety gear
backwards.
CONTROL OF ALL OPERATIONS
Subsequently, the release is to be controlled at a nominal speed, as well as the relative safety devices.
The control of the release is to be carried out as a dynamic function test, with or without rated load of the
elevator car.
During test runs, no-one must stay in the elevator car.
Crush danger!
During this operation, never put the hands or other parts of the body inside the governor, because
the release of the moving cheek could cause injuries.
The safety switch must release and switch off the safety circuit of the elevator plant.
With a slow movement downwards/upwards, bring the overspeed governor and the brake device (the safety
gear) back again.
CONTROL OF THE SAFETY DEVICE FOR ROPE TENSION
The safety switch on the tension weight with counterweight is controlled by removing the rope of the over-
speed governor from the rope pulley.
When the control is finished, the release pin of the safety switch must be reset by hand.
53
Publicité
