Changing The Basic Settings; Care And Cleaning - Siemens ET375MU11E Mode D'emploi

Changing the basic
settings
Switching off without storing To exit the basic setting, switch off the grill with the
the settings

Care and cleaning

Draining the water
40
The grill must be switched off.
1.
Switch on the grill.
2.
Within the next 10 seconds, touch the
for 4 seconds.
2
display and
W
3.
Touch the
symbol appears on the right-hand display.
4.
Set the desired value on the control panel.
W
5.
Touch the
The setting is activated.
main switch. The changes of the settings will not
be saved.
Do not use high-pressure or steam jet cleaning
devices.
Caution, risk of burns! Wait until the residual heat
display has gone out before cleaning the grill.
Clean the grill after every use. Burnt in residues may
be difficult to remove.
In the event that the water is still hot when drained,
add some cold water to the container to cool it!
To drain the water, place a heat-resistant container
beneath the drain valve. Open the drain tap by
turning the lever down by 90°. Then close the tap by
turning the lever fully up.
c2
appears on the right-hand
on the left-hand display.
symbol repeatedly until the desired
symbol for 4 seconds.
W
symbol