AEG TI84IB30FZ Notice D'utilisation page 20

• Do not spot halogen light on the hood
panel.
• Do not cover the hob control panel.
• Do not interrupt the signal between the
hob and the hood (e.g. with the hand, a
cookware handle or a tall pot). See the
picture.
The hood pictured below is for illustration
purpose only.
9. CARE AND CLEANING
WARNING!
Refer to Safety chapters.
9.1 General information
• Clean the hob after each use.
• Always use cookware with a clean base.
• For both daily cleaning of the glass
surface and the post-installation cleaning
and removal of any residual glue, use only
a mildly abrasive cleaning milk and an
anti-scratch, delicate sponge. Depending
on the degree of soiling, clean the glass
surface with small circular movements and
moderate pressure. Wipe the glass
surface dry with a microfibre cloth.
WARNING!
Do not use the classic yellow and
green sponge as the aluminium
particles on its hard layer may
damage and discolour the glass.
20 ENGLISH
Other remotely controlled appliances
may block the signal. Do not use any
such appliances near to the hob while
Hob²Hood is on.
Cooker hoods with the Hob²Hood function
To find the full range of cooker hoods which
work with this function refer to our consumer
website. The AEG cooker hoods that work
with this function must have the symbol
Using cleaning tools different than the
recommended ones will not be
effective and may damage or
discolour the glass surface.
• Always use a scraper recommended for
hobs with a glass surface. Use the scraper
only as an additional tool for cleaning the
glass after the standard cleaning
procedure.
WARNING!
Do not use knives or any other sharp,
metal tools to clean the glass surface.
9.2 Cleaning the glass surface of
the hob
• Remove immediately: melted plastic,
plastic foil, salt, sugar and food with sugar,
otherwise, the dirt can cause damage to
the hob. Take care to avoid burns. Use a
special hob scraper on the glass surface
.