Publicité
Les langues disponibles
Les langues disponibles
6. Reposition the bed rails in the bed so that the
correct square 5/8" hole in the end of each rail is
lined up over the drilled holes. Place a 1" spacer
tube (#8) under end of each bed rail, in line with
the drilled holes. See Illustration "D" on Page 3
Bed Spacer
Plate(# 9)
9
8. Position the brackets so that they rest tightly
against the flat side of the truck frame and
underneath surface of truck bed. Drop the 5/8"
hex bolts(#5) down through the lock
washer(#6), flat washer (#7) ,bed rails, spacers
and brackets. Be sure the brackets are tight
against the side of truck frame before
tightening bolts. Hand tighten the 5/8" hex
bolts.
9. Before drilling any holes in truck
frame, check inside the frame to
be sure that there are no wires,
brake lines or other obstructions in
the frame which may be contacted
by the drill. Each of the brackets
must be attached with two bolts.
The Driver side front bracket is
attached with one wheel bolt
through drilled hole #1 and the
carriage bolt through the hole #2.
The carriage bolt (#14) pass
through spacer plate(#15), frame
,bracket (#1), flat washer(#16),
lock washer(#12) and hex
nut(#13). See Illustration "F".
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information/ Tech Support.
2020 Keystone Automotive Operations Inc. All Rights Reserved. 09/21/2020-Rev4
9
Illustration "E"
1
10
Illustration "F"
Bed Rail
Truck Bed
7. The bed corrugation above the
bracket is UP, leaving a space
above the bracket. Insert the sort
end of spacer plate (#9) in this
location as shown on Illustration
"E".
TRUCK BED
12
13
FRONT DRIVER SIDE SHOWN
Illustration "D"
11
TRUCK
FRAME
16
12
13
8
BASE
RAIL
14
15
Page-5
Publicité
