Publicité
Les langues disponibles
Les langues disponibles
DO NOT install mounting rails over plastic bed liners. Plastic bed liners must be cut out of the
way.
Base rails may be installed on dry/cured spray in liner. Note: Consult installer for recommended
curing
time.
DO NOT install this kit on truck with less than 6' bed.
Use only the supplied bolts, nuts, and washers to install this kit. All nuts and bolts are Grade 5
unless specified otherwise.
These instructions are guidelines only. Actual installation is the responsibility of the
installer and
the owner. Always measure truck and trailer before installing hitch to be sure that there is
clearance at the cab and at the bumper to allow for turns.
The following instructions should be used to mount the fifth wheel. Care and attention to detail will
ensure a quick quality installation. Check parts against parts list to become familiar with parts in kit.
1. The wheel well liners will need to be removed to access the frame for bracket installation.
2. Place the two bed rails across the truck bed between the wheel wells. Securely attach the 5th
wheel cross member to uprights. Position the 5th wheel uprights between the bed rails so that
the tabs in the base of each upright will fit into the slots in the bed rails. Secure the uprights in
place with the rail hitch pins and hair pins supplied with the 5th wheel installation kit
3. On most applications, the 5th wheel assembly should be positioned so that it is approximately
centered over the truck axle ( in this case ahead of axle) and between the wheel wells on the
bed floor.
4. Position the bed rail assembly in truck bed as shown on the Illustration "B" on page 3 of this
instruction sheet. When hitch is correctly positioned in the bed and the bed rails are parallel,
mark four attachment points on the truck bed using the 5/8" square holes indicated on the
layout Illustration as guides. Check below the bed before drilling holes to see that all wiring,
brake lines, or other obstructions are moved out of the way and will not be contacted by the
drill. Move the hitch assembly out of the way and drill four 5/8" diameter holes down through the
bed at the previously marked points.
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines,
structural members, etc. HUSKY TOWING PRODUCTS does its best to communicate tow vehicle
manufacturer changes; however, it is ultimately the responsibility of the installer to prevent damage
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information/ Tech Support.
2020 Keystone Automotive Operations Inc. All Rights Reserved. 09/21/2020-Rev4
CAUTION:
due to installation.
Page-3
Publicité
