Whirlpool Cabrio Serie Guide D'utilisation Et D'entretien page 7

CYCLE GUIDE -- MANUAL CYCLES
Settings and options shown in bold are default settings for that cycle. Not all features and cycles are available on all models.
Not all settings and options are available on each cycle. Default cycle times are estimated in minutes.
Time Adjust
Adjusting drying time on Timed Dry Cycles
E_t. r_m_ R_m_ n _,_ When you select a Timed Dry Cycle,
the default time appears in the display.
Use the Time Adjust buttons to increase
or decrease the time in 1 minute
increments. Press and hold to change
the time in 5 minute increments.
The maximum dry time is 90 minutes.
Selecting the Temp
A High heat setting may be used for drying heavyweight
items such as towels and work clothes.
A Low to Medium heat setting may be used for drying
medium-weight items such as sheets, blouses, dresses,
underwear, permanent press fabrics, and some knits.
Use a no-heat (Air Only) setting for foam, rubber, plastic,
or heat-sensitive fabrics.
Line dry bonded or laminated fabrics.
NOTE: If you have questions about drying temperatures
for various loads, refer to the care label directions.
Items to dry; Cycle:
' ' • Time:
Small loads and
sportswear
Any load
NOTE: Select Air
Only to dry foam,
rubber, plastic, or
heat-sensitive
fabrics
Quick Dry
Timed Dry
Touch Up
(for non-steam
models)
Small to medium
loads
il _ ii ii i _ ii _,! _i_ i_ i1_ i ii _ _ i_i _ _i _ i _i_ _ i ii _ __
Temp: Default Available Cycle Details:
Options:
13 Wrinkle Shield t _ For small loads of 3-4 items.
High
Medium
Low
Extra Low
Air Only
High
Medium
Low
Extra Low
Air Only
High
Medium
Low
Extra Low
Air Only
4O
2O
Wrinkle Shield t
Wrinkle Shield t
i Use to dry items to a damp level for items that do
not require an entire drying cycle. Select a drying
temperature based on the type of fabrics in your
load. If you are unsure of the temperature to select
for a load, select the lower setting rather than the
higher setting.
Use this setting to help smooth out wrinkles from such items as garments packed in a suitcase or
garments wrinkled from being left in the dryer.
Or Wrinkle Shield
TM
with Steam (on some models). Wrinkle Shield
TM
with Steam is available only with High and Medium Temp settings.
CYCLE GUIDE- STEAM CYCLES
Settings and options shown in bold are default settings for that cycle.
Not all settings and options are available on each cycle.
Steam cycles are designed for use with dry loads to loosen wrinkles, reduce odors, and refresh fabrics.
temsto I I Oefau t Ava,ab e
refresh' Cycle: Temperature: Time: Options:
Mixed loads Enhanced High 22 Wrinkle Shield t
Touch Up Medium Static Reduce
Shirts, blouses,
and slacks
Quick
Refresh
(on some
models)
Medium 12 Wrinkle Shield t
Static Reduce
©
Or Wrinkle Shield
TM
with Steam (on some models). Wrinkle Shield
TM
with Steam is available only
Use to reduce odors and light wrinkles from small to
medium-sized loads of dry items. Dry time will
automatically adjust when the load size is sensed.
Cycle run time cannot be manually adjusted.
Temperature is selectable. Do not add dryer sheets.
The Quick Refresh cycle is best for reducing light
wrinkles and odors from dry garments, including
loads left in the dryer. For the Quick Refresh cycle,
time is selectable in 5 minute increments, based on
the load to be refreshed.
with High and Medium Temp settings.
Load Size Recommendations
For best results, follow the load size recommendations noted for
each cycle.
Small load: Fill the dryer drum with 3-4 items,
not more than 1/4 full.
Medium load: Fill the dryer drum up to about 1/2 full.
Large load: Fill the dryer drum up to about 3/4 full.
Do not overload. Items need to tumble freely.