Publicité
Les langues disponibles
Les langues disponibles
Issue
Pressure washer will not
start.
The pressure washer
creates low or no water
spray pressure.
Detergent fails to mix with
the spray.
Page 18
TROUBLE SHOOTING
Possible Cause
The power supply cord is
not connected.
The house circuit breaker is
The GFCI equipped
receptacle (if applicable) is
The GFCI in the power
supply cord is tripped.
The master ON/OFF switch
is in the OFF position.
The thermal switch has
There is air in the hoses
and/or pump.
The water supply is
insufficient.
The nozzle is clogged.
The water inlet screen is
Transparent tube is clogged
Transparent tube is not
attached to the pump.
Incorrect nozzle used.
Detergent too thick.
tripped.
tripped.
tripped.
clogged.
or cracked.
Solution
Plug the cord into a
receptacle of the proper
voltage and amperage.
Reset the circuit breaker.
Reset the GFCI by pushing
the RESET button.
Reset the GFCI by pushing
the RESET button.
Move the switch to the ON
position.
Turn the master ON/OFF
switch to the OFF position.
Allow the unit to cool for
30 minutes before trying
the pressure washer once
again.
Refer to the PRIMING
THE PUMP section of this
manual to remove air from
pump and hoses.
Make sure the water supply
pressure is at least 5 gpm
@ 20 PSI.
Clean nozzle per the
MAINTENANCE section of
this manual.
Clean the water
inlet screen per the
MAINTENANCE section of
this manual.
Clean or replace the
transparent tube.
Attach the transparent tube
to the detergent connector
on the pump.
Install the black soap
nozzle on the wand.
Add water to the detergent
to make it the consistency
of water.
Publicité
