Publicité
the voltage, current and load indicated on the tag and having
the earth contact. The socket must be suitable for the load in-
dicated on the tag and must have ground contact connected
and in operation. The earth conductor is yellow-green in col-
our. This operation should be carried out by a suitably quali-
fied professional. ln case of incompatibility between the socket
and the appliance plug, ask a qualified electrician to substitute
the socket with another suitable type. The plug and the sock-
et must be conformed to the current norms of the installation
country. Connection to the power source can also be made by
placing an omnipolar breaker, with contact separation compli-
ant to the requirements for overvoltage category III, between
the appliance and the power source that can bear the maxi-
mum connected load and that is in line with current legislation.
The yellow-green earth cable should not be interrupted by the
breaker. The socket or omnipolar breaker used for the connec-
tion should be easily accessible when the appliance is installed.
The disconnection may be achieved by having the plug accessi-
ble or by incorporating a switch in the fixed wiring in accordance
with the wiring rules.
• lf the power cable is damaged, it should be substituted with a
cable or special bundle available from the manufacturer or by
contacting the customer service department. The type of pow-
er cable must be H05V2V2-F. This operation should be carried
out by a suitably qualified professional. The earth conductor
(yellow-green) must be approximately 10 mm longer than the
other conductors. For any repairs, refer only to the Customer
Care Department and request the use of original spare parts.
• Failure to comply with the above can compromise the safety of
the appliance and invalidate the guarantee.
• Any excess of spilled material should be removed before clean-
ing.
• A long power supply failure during an occurring cooking phase
may cause a malfunction of the monitor. ln this case contact
EN 5
Publicité
