Publicité
Les langues disponibles
Les langues disponibles
6. Apply grease to the outside of the clamping jaw
assembly
19
.
7. Put the jaw assembly
19
mount it onto the tool. Tighten the pulling hull by hand and
ensure it is secured by the locking sleeve
nOTE: A molybdenum disulfide‑based grease
is recommended.
8. Mount the nose housing and nose housing nut and tighten
by hand.
Cleaning the Tool Exterior (Fig. A)
Keep the brushless motor exhaust vent
dust and dirt. If necessary, use a soft, moist cloth to remove dust
and dirt from the exhaust vents. Blow dirt and dust out of the
main power tool housing with dry air as often as dirt is seen
collecting in and around the exhaust vents.
Optional Accessories
WARNING: Since accessories, other than those offered
by D
WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and batteries marked
w
with this symbol must not be disposed of with
normal household waste.
Products and batteries contain materials that can
be recovered or recycled, reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long‑life battery pack must be recharged when it fails to
produce sufficient power on jobs that were easily done before. At the
end of its technical life, discard it with due care for our environment:
•
Run the battery pack down completely, then remove it from
the tool.
•
Li‑Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
into the pulling hull
and
18
17
.
openings free from
7
WALT-recommended
e
EnGLIsh
33
Publicité
