Nakayama MB5005 Mode D'emploi page 4

EN
General Safety Instructions
Prior to the initial use of the unit, the operating instructions should be read completely. If in doubt with regard to connection
and operation of the unit, consult the manufacturer (Servicing Department)
FOLLOW THE INSTRUCTIONS BELOW CAREFULLY IN ORDER TO SECURE A HIGH DEGREE OF SAFETY:
CAUTION!
1. Pay attention to the conditions of the area, which you're working in. After the engine is started, power machine will
produce poisonous gas. The gas may be invisible and odorless. Hence never work with the machine in closed or poorly
ventilated areas. Provide for good lighting when cutting. Provide for stability when cutting in wet, snow or icy weather
conditions on slopes or rough ground.
2. Do not let any unauthorized persons approach the machine. The visitors and viewers, primarily the children, the ill and
infirm persons should not have any access to the working area. Don't let other persons touch the machine.
3. Make provision for the tools storage. When the machine is not being used, it should be kept in a dry place, elevated or
locked so that any access to the machine is prevented.
4. Always use the correct tool for the job to be done. E.g. avoid using small tools and accessories for work that should be
performed with a heavy tool. Use the tools only for the purposes they were designed for.
5. Pay attention to adequate clothing. The clothing should fit the purpose and should not limit your movement when
working.
6. Use personal protective equipment. Wear safety shoes with steel toes and antiskid or rough sole.
7. Wear goggles. Object may be thrown towards you.
8. Wear hearing protectors. Wear personal protective equipment to protect your hearing, such as hearing protectors.
9. Hand protection. Wear hard gloves of chrome tanned side leather for sufficient protection.
10. Transport. The tiller should be always transported with the driving wheel in transport position. Make sure that nobody is
exposed to risk when the tiller is put out of service. Secure the unit against tilting, damage and fuel leakage.
11. Remove the wrench etc. Any wrenches/spanners etc. must be removed before the tiller is put on.
12. Be attentive any time. Mind what you are doing. Use common sense. Do not use the tiller when tired. Never work with
the crusher when influence by alcohol, drugs or medicaments affecting the concentration capability.
13. Refueling. Always switch the engine off before refueling. Open the tank closure carefully for overpressure run out slowly
and the fuel ejection is prevented. When working with the tiller, the unit body temperature increased. Let the unit cool
down before refueling. Otherwise, the fuel could ignite and persons get burnt. Beware of overfilling the tank. If there is a
spill, remove it and clean the unit. After finishing the refueling, make sure the screwed closure is tight to avoid loosening
in result of vibrations.
14. Watch out for any damaged parts. Inspect the machine before use. Are any parts damaged? Ask yourself seriously when
detecting slight damage whether the machine will work perfectly and safely despite that. Watch out for proper aligning
and adjustment of any moving parts. Are the parts tightly connected with each other? Is any part damaged? Is
everything installed properly? Are any other prerequisites of proper working in place? Damaged protective devices etc.
must be repaired or replaced by authorized entitles unless the operation manual expressly says otherwise. Any
defective switches must be replaced at an authorized servicing centre. Do not use the machine if it cannot be put on
and off with the switch. When repairs are necessary, kindly turn to your local servicing centre.
15. Switch the engine off before any adjustment and maintenance. That applies to the blades replacement in the first place.
16. Use approved parts only. Use only identical spare parts for maintenance and repairs. Request advice of an authorized
servicing centre for this purpose.
Emergency action
Apply the first aid adequate to the injury and get qualified medical assistance as quickly as possible. Protect the injured
person from more accidents and calm him/her down.
Intended use
The unit is designed only for regular use in agriculture, forestry, and horticulture and area treatment. The manufacturer
shall not be held liable for any personal and material losses due to a failure to observe these rules.
4
WWW.NIKOLAOUTOOLS.GR