Table Des Matières; Introduction; Product Description; Intended Use - pullman Ermator T 7500 Manuel D'utilisation

Introduction..................................................................... 2
Safety..............................................................................6
Assembly........................................................................ 8
Operation........................................................................ 8
Maintenance................................................................... 9

Product description

The product is a dust extractor with a suction hose. Air
with dust is suctioned into an inlet valve through the
suction hose. The air decreases in speed by a cyclone
which cause the dust particles to move apart from the
air. Small dust particles and air goes through a 2 filter
system. Large dust particles are collected in the cyclone
and fall through the bottom flap into a plastic bag.

Intended use

The T-Line Dust Extractor is used to clean construction
areas by collecting up dry and non flammable dust in
indoor environments.
The T-Line Dust Extractor can be connected to medium
and large surface preparation equipment such as
grinders.
2
Contents
Troubleshooting............................................................ 13
Transportation, storage and disposal........................... 13
Technical data.............................................................. 15
EC Declaration of Conformity....................................... 16

Introduction

The T-Line Dust Extractor is intended for commercial
use, for example in hotels, schools, hospitals, factories,
shops, offices and rental businesses
Note: The explosion limit value for the not flammable
dust is >0.1mg/m
Dust storage system
All Pullman Ermator T-Line Dust Extractors are to be
used with Longopac. Only change Longopac after the
filter cleaning cycle has been completed.
3
.
966 - 003 -