Alpina CH-Y02S Manuel D'utilisation page 7

To avoid danger to life from environmental factors:
• In order to avoid overheating, do not cover the heater
• Do not place the appliance out in the rain. Do not use
it in a humid or wet environment.
• Do not use the appliance if there are glowing, hot or
spark-generating parts inside it. Do not use the
appliance in the vicinity of flammable or explosive
liquids or gases.
• Always position or attach the device in such a way that
combustible articles cannot catch fire.
• Always position or attach the device out of reach of
people bathing, showering or swimming.
• Do not position the device directly below an electrical
wall socket.
WARNING! Do not cover. Make sure that the
appliance does not become covered by towels,
curtains or similar objects as this could lead to
overheating. You must ensure that the air inlet and
outlet openings (2 and 5) are always unobstructed.
Do not install the appliance immediately below a
•
socket-outlet.
Assembly
Attaching the feet (refer to Fig. B):
1. Lay the convector heater carefully on its side.
2. Place the feet (4) under the convector heater in such a way that the
screw holes are correctly aligned.
3. Tighten the screws (4) until they are hand-tight. The feet (7) should
now be securely attached. Note: When deciding on the position of the