VINCENT SA-T7 Diamond Manuel D'utilisation page 35

CONNECTION OF ONE OR MORE POWER AMPLIFIERS
SA-T7MK Diamond
The fact that this amplifier is equipped with two RCA stereo preamplifier outputs enables you to bi-wire your
loudspeakers using adequate speakers and one or more additional main amplifiers. For the best rendering,
amplifiers with transmission inputs (e.g. studio amplifiers) should be connected with the optimal output labeled
„1" in „Outputs". Vincent amplifiers generally have input impedances > 10 kOhm and can be connected to
outputs „1" and/or „2" anytime. Your HiFi specialist will advise you on this.
CONNECTIONS FOR THE STANDBY CONTROL
Many AV-Systems consist of a multitude of individual components. To avoid the necessity of switching them
on and off before and after every use, many manufacturers have equipped their devices with what is known
as "POWER CONTROL" circuit or "TRIGGER". This kind of remote-controlled standby circuit is used primarily
for preamplifier and power amplifiers. Particularly for preamplifiers and main amplifiers this kind of remote
standby control is utilized, as power amplifiers are often placed far from other devices near the speakers. To
employ these functions, direct or indirect cable connections must be made between the preamplifier (or integ-
rated amplifier) and all the devices which support this function. The "POWER CONTROL" function operates in
such a way that each switching on or off of one device in the system (usually the preamplifier) automatically
brings about the switching on or off of all the connected devices which support this function. Please keep in
mind that all devices which respond to the power control are not disconnected from the mains network when
switched off. They are set to a standby state instead. For connecting cables, two-core cables with 3.5 mm jack
plugs (mono) are used. For each connection between two devices one of those cables is needed.
If you don't wish to use this function or if the other components do not support it, all you have to do is leave out
these cable connections.
The SA-T7MK is equipped with two output connectors for the power control. Here, the switching signal ge-
nerated by the SA-T7MK is available for other components of the system. Two HiFi components that are
able to react to the power control signal can be connected directly to the amplifier's power control outputs.
If more than two devices, which can be controlled, are to be connected, then it is necessary to make the
RCA connection
(POWER CONTROL)
stereo main amplifier
INPUT
e.g. a second
stereo main amplifier
INPUT
35