VINCENT SA-T7 Diamond Manuel D'utilisation page 32

Set up the cable links in a sequence as follows. Connect the power cable between de-
vice and power supply only after all other connections have been made.
Protective caps
Prior to the first installation the protective plastic caps
must be removed from all the connections used at the
rear of the unit.
RCA connections
Mechanically identical RCA plugs are available for
input and output connections. Make sure that you do
not get these connections confused during installation!
Make sure that you do not mix up the analogue inputs
for right and left. The RCA plugs for these are most-
ly colour coded as follows: red for the right channel,
black or white for the left channel.
Contacting the middle pin of the RCA plugs with the
outer ring of the RCA chassis jack may lead to dama-
ges to the main amplifier if it is switched on! To avoid
this hazard, connect or disconnect only in switched-off
state and more than one minute after deactivating!
32
INSTALLATION
DURING INSTALLATION PLEASE OBSERVE
THE FOLLOWING ADVICE:
Cable connections
Make sure that all plugs fit tightly. Inadequate connec-
tions can cause noise interference, failures and mal-
functions.
- wrong -
To make the most of the components' sound potential,
only high quality loudspeakers and connecting cab-
les, for example Vincent cables, should be used. Your
local dealer will be glad to advise you about this.
- correct -