Jenn-Air W11231557A Instructions D'installation page 7

1. Mount the panel alignment tool onto the refrigerator door.
Align the smaller piece with the screws on the bottom of
■
the door, and slide it to the left.
Assemble the panel alignment tool by inserting the long
■
arm of the main piece into the cutout of the smaller piece,
and adjust it so that the base is at the appropriate height,
aligned with the base of the surrounding cabinet doors.
Use a screwdriver to tighten the panel alignment tool's
9.5 mm screw and hold it in place.
2. Attach the refrigerator door panel.
Peel the protective paper covers off of the adhesive pads
■
on each refrigerator door panel mount. There are two
adhesive pads on each of the four panel mounts.
At an angle, rest the base of the refrigerator door panel on
■
the panel alignment tool.
Slowly tilt the panel to attach it to the adhesive pads on
■
the panel mounts. Firmly press against the corners of the
door to ensure that the panel is properly attached to the
adhesive pads.
3. Loosen the panel alignment tool's screw and remove the tool
from the refrigerator door by sliding it to the right and off of
the door.
4. Mount the panel alignment tool onto the freezer door. Repeat
step 1 in refrigerator.
5. Attach the freezer door. Repeat step 2 in refrigerator.
6. Loosen the panel alignment tool's screw, and remove the tool
from the freezer door by sliding it to the right and off of the
door.
09-Mar-2018 14:10:27 EST | RELEASED
7. Open both doors and fasten the panel mounts to the door
panels. All eight panel mounts (four on each door) should be
fastened in the same manner:
Use a Phillips screwdriver and two 13 mm screws (one at
■
the top of the mount and one at the bottom of the mount)
to fasten the mount to the door panel.
Locate the two slotted headless screws, and use a flat-
■
blade screwdriver to turn the bottom headless screw
clockwise. This loosens the panel mount brace, which is
between the panel mount and the door panel. Remove
and discard the panel mount brace.
8. Finalize the placement of the door panels by using the
alignment screws on the panel mounts.
C
NOTE: Make sure that the door panels do not come into direct
contact with any of the surrounding cabinets or cabinet doors.
Such contact could prevent the refrigerator and/or freezer door(s)
from closing properly.
The top-slotted headless screw (A in the illustration) adjusts
■
the spacing between the door and the door panel. Use a
flat-blade screwdriver to make adjustments. Turn the screw
clockwise to increase the space between the door and door
panel and counterclockwise to decrease the space.
NOTE: When the doors are closed, there should be a
minimum of 1 mm of space between the rear face of the
door panels and the front face of the frame. Use the top-
slotted headless screw to add more space if necessary.
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
A
B
7